Tank Degresol A Heavy Duty 20 Ltr

Product Description

Concentrated effective cleaner for contaminated FUEL OIL , cargo tanks . It’s high emulsification formula easily react with residue / sludge deposits .RXSOL-20-2029-020 is  used  as  a tank cleaner or for general degreasing , cleaning and gas freeing for double bottom tanks, wing tanks, tank lines, fuel oil tanks, etc .
 

Product Technical bulletin

TANK DEGRESOL A HEAVY DUTY (RXSOL-20-2029-020)

Introduction: (Solvent based oil and grease remover) Highly concentrated solvent emulsifier, with powerful penetrating agent corrosion inhibitor  and  surfactants,  RXSOL-20-2029-020 is  used  as  a tank cleaner or for general degreasing , cleaning and gas freeing for double bottom tanks, wing tanks, tank lines, fuel oil tanks, etc .

Tank Lining–Stainless /Zinc/Epoxy/Phenolic.
Using-Procedure : 

Following the re-circulation process, the tank must be hot butterworthed 80-85o C for at least 6 hours.
*Use a strainer at the pumpstack when circulating any solution RXSOL-20-2029-020 is recommended for local cleaning and degreasing and may be applied  by  brush,  hand  spray, immersion, soaking or any other conventional means. Apply concentrate RXSOL-20-2029-020 over  soiled  area  and wait for 20-30 minutes before rinsing off with water.

Soak-Method: For heavy oil and soil Put parts to be cleaned into a bath of concentrate RXSOL-20-2029-020 and for medium to light soiling use a solution of 10-30% RXSOL-20-2029-020 in water. Parts should be soaked for at least  30 minutes  before washing off with water.

Spray-Method: Spray concentrate RXSOL-20-2029-020 over all soiled areas.With in15 and 30 minutes,RXSOL-20-2029-020 starts its function then rinse off by water hose.For stubborn deposits, agitation by scrubbing will  assist  the  cleaning operation

Cargo Tank Cleaning after Mineral Oils
Direct injection method: Make  a   solution  of RXSOL-20-2029-020 between 0.1 and 2.0% i.e. one to twenty litres  per ton wash water.Then use with Tank cleaning machine,Best results are obtained when water is heated to a temperature between 60  to  80°C.Slops Should be Constantly Stripped from, tank.                                                   

Recirculation method / Ship’S Rocking Motion: Make  soln.  Strength  with RXSOL-20-2029-020 between  0.5 –3 %  and  used  with  Tank Cleaning machines OR fill the tank to 20-30% volume with sea water and add the RXSOL-20-2029-020 up to full dose  . For better  results  heat  the solution  between 60 – 80°C. NOTE :Dose rate and results will vary depending on amount of contamination.

Spot cleaning: RXSOL-20-2029-020 (concentrate) can be sprayed over surfaces and left  for  20 – 30 minutes  Finally wash down the tank surfaces with hot  water between 60°C and 80°C with  high  pressure   machine .   Keep stripping tank slops and transfer to holding tank/slop tank. Cleaning  of  the Oil  side of  Lube  Oil Heat Exchangers  Cleaning  is  best  achieved  by the recirculation method using a heated 20% solution of RXSOL-20-2029-020

1)First of all drain off any remaining oil from Heat Exchanger.
2)Connect the discharge side of a portable pump to the lower heat exchanger connection & the suction Side of the pump to the bottom outlet of a 200 litre drum.
3)Complete the circuit by connecting the upper connection on the heat exchanger to the top of the drum.
4)Maintain the bath temperature between 60-80 0 C throughout the cleaning operation.  If it is not possible to heat, the operation will need to be extended.
5)Use the pump to maintain circulation for 12 to 15 hours.  When the cleaning is completed, disconnect the lower heat exchanger connection and drain out the cleaning solution.
6)Connect a fresh water supply to the upper heat exchanger connection, and rinse until the water runs clean from the lower connection.When rinsing is complete, disconnect the water supply and thoroughly drain and dry the heat exchanger.

Product Properties :

Used as a multi-purpose degreaser in extremely hard cleaning conditions

Characteristics :
• It is cost effective, easy to apply and use.
• High emulsification on mineral oils and petroleum based chemicals.
• Safe to use on most metal surfaces, painted surfaces and tank coatings.
• Cleans oil coolers, fuel oil pre heaters and lube oil heat exchangers.
• Removes general oil contamination from machinery and engine room.
• Economical  cost effective  .

For detailed information on safety & health, Please refer to Material Safety Data Sheet & /or Product Label

Product label
RXSOL-20-2029-020
Concentrated effective cleaner for contaminated FUEL OIL , cargo tanks . It’s high emulsification formula easily react with residue / sludge deposits .RXSOL-20-2029-020 is used as a tank cleaner or for general degreasing , cleaning and gas freeing for double bottom tanks, wing tanks, tank lines, fuel oil tanks, etc .